Robert Wood posted an answer for this Ford Cars & Trucks:
"Is there a decal under the hood or in the engine compartment with a Calibration number..."
Robert Wood posted an answer for this 2013 Dodge Charger:
"The high and low pressure switches need verification that they , their wiring and..."
Robert Wood posted an answer for this 1997 Dodge Ram 3500 Club Cab:
"After the charging light comes on what voltage does it read with a volt meter connected to..."
Robert Wood posted an answer for this 2006 Chevrolet Trailblazer:
"Has it not ran since throttle body and battery replacement ?"
Robert Wood posted an answer for this Cars & Trucks:
"Park neutral switch ? Backup light circuit may be shorting power to ground ."
Robert Wood posted an answer for this Chrysler Cars & Trucks:
"Check below the passenger side headlight"
Robert Wood posted an answer for this Cars & Trucks:
"Have you tried priming the throttle body with starting fluid spray to see if it starts..."
Robert Wood posted an answer for this Buick Cars & Trucks:
"What are the oxygen sensors or fuel ratio sensors readiing when acting up ? The..."
Robert Wood posted an answer for this Chevrolet Cars & Trucks:
"Hi Joe . The battery connections to the starter may need cleaning and tightening as well..."
Robert Wood posted an answer for this Cars & Trucks:
"As Eric stated more information is needed. Several wires , connectors, switches and..."
Robert Wood posted an answer for this Cars & Trucks:
"Does the left brake light work when brake is applied ? The power to the parking light..."
Robert Wood posted an answer for this Oldsmobile Cars & Trucks:
"Cam or crank sensor may be heat failing. Ignition module or coils heat failing."
Robert Wood posted an answer for this Nissan Cars & Trucks:
"Are you missing spark , fuel , injector pulse , ignition pulse etc. ?"
Robert Wood posted an answer for this Ford Cars & Trucks:
"Air between the pump and carb or between the pump and fuel tank ?"
Robert Wood posted an answer for this Pontiac Cars & Trucks:
"Is the engine knocking ? It may be an idle issue"
Robert Wood posted an answer for this Cars & Trucks:
"Double check all connections between starter motor and switch ."
Robert Wood posted an answer for this Cars & Trucks:
"Downstream O2 sensors monitor the health of the catalytic converter and the upstream O2..."
Robert Wood posted an answer for this Cars & Trucks:
"The tail light assembly contains the circuit boards on each side. Driver side and..."
Robert Wood posted an answer for this GMC Cars & Trucks:
"Intermittent crank sensor failure . Heat failure"
Robert Wood posted an answer for this Cars & Trucks:
"Restricted exhaust . Catalytic converter or muffler may be restricted ."
Robert Wood posted an answer for this Cars & Trucks:
"Appears to be below the ignition coil assembly . Getting to it with the vehicle on a lift..."
Robert Wood posted an answer for this 2005 Buick Rendezvous:
"If the coils are not getting the proper control signal they can throw a code . Do you have..."
Robert Wood posted an answer for this Dodge Cars & Trucks:
"Does it not have electronic point less ignition ?"
Robert Wood posted an answer for this 1999 Chevrolet S-10:
"I know it's an old post but the serpentine belt on some engines may hit the crank sensor..."
Robert Wood posted an answer for this 1992 Pontiac Grand Am:
"Ignition switch may be going bad ."
Robert Wood posted an answer for this Dodge Cars & Trucks:
"What was done for the "tune up "?"
Robert Wood posted an answer for this Honda Cars & Trucks:
"Short to ground possible . Is it the fuse for the ECM blowing or the ECM itself burning..."
Robert Wood posted an answer for this Buick Cars & Trucks:
"Agree on testing battery voltage and connections first . Check engine ground point also ."
Robert Wood posted an answer for this Buick Cars & Trucks:
"Does the pump not hum when initially engaging ignition switch ? Possible ground issue. Was..."
Robert Wood posted an answer for this Cars & Trucks:
"Agree with Carl . Need Injector verified ."