Press enter to search.
Shirley Neibarger posted an answer for this Juki Sewing Machines:
"Are you sure it's a 5 thread?
I looked at the threading diagram on the 804 and it appeared..."
"Remove the foot and plate. Take your thread out of the needle and see if you can run the..."
"Frances, Check to make sure that you don't have a bad needle. If there is a slight burr on..."
"Generally the machine is making poor stitches going forward before it makes skipped..."
Shirley Neibarger posted an answer for this Bernina Sewing Machines:
"On the right side of your machine, below the hand wheel, there is a small knob. When you..."
Shirley Neibarger posted an answer for this Sewing Machines:
"Your stitch selector knob is still set on the 3rd leg of the buttonhole. Turn your knob..."
"Generally you have been making buttonholes and have not put the stitch type back onto..."
"Loosen your top tensions (large tension near the needle, small tension near the top of the..."
"Oil generally helps. Put a couple drops of oil on screws and let set a while.
"There is a clear oil gunge cap on top of the machine.It probably is clear and has a small..."
"Make sure that your bobbin is all the way into the case
Make sure that your needle is up..."
"I am surprised that you have to set the needle bar but put a NEW needle in the bar or make..."
"It is generally because you have not taken your knee completely off the knee lift...."
"Check to make sure that your needle is completely inserted up into the machine, and that..."
"If it is 110 motor, check with your mechanic.
If it is 220/3 phase industrial, your poles..."
Shirley Neibarger posted an answer for this Juki America, Inc Juki MO-644D 2/3/4 Thread Overlock Serger JUKI010:
"Check the pulley on your motor. Sometimes thread gets wrapped around the pulley and can..."
"I am surprised that I couldn't find threading directions in the manuals that I found. It..."
"Did you get this fixed?
Most common problems:
1. You broke a needle and the hole in your..."
"Did they break or are they scared up?
It's not easy to get them right. But try this...."
"Please send a picture of your machine. I can't find Juki and 932 on line unless you are in..."
"I am confused as to why one place on this says Juki cp-160 and one says DDL-8500-7
"Have you moved your sewing machine lately? I don't know what model your machine is, but I..."
"Try a different thread. Did it act ok on that thread? Usually it is because the shuttle is..."
"Is the motor 110? or 220/3 phase. If the wires are reversed on the motor, it will only run..."
"See if it is set for buttonhole on the #3 step"
"Both the motor and the light work off the switch box separately USUALLY.
1. Look under..."
Shirley Neibarger posted an answer for this Juki MO-644 Mechanical Sewing Machine:
"I think the right 'finger' on the plate is out too far. You may need to adjust your..."
"As a general rule the left cover needs to have its top aligned with the plate and then..."
"Are you running your thread through the small tension at the upper right of the machine..."
"Turn it to either extreme and then see if the feed dogs hit the plate when you hand turn..."
Shirley Neibarger posted an answer for this Juki MO-623 Mechanical Sewing Machine:
"DC x 1 should be your needle type.
Try this company for your manual:
Juki MO-2500 Parts -..."
Load more activity...
19,487 people helped
View all achievements