ANALOG ELECTRONICS DESIGN ENGINEER
soundproman7 posted an answer for this Behringer Eurorack Ub802 - Ultra Low-Noise Design 8-Input 2-Bus Mixer:
"The microphone preamps are different. The Xenyx has lower noise mic preamps."
soundproman7 posted an answer for this Behringer Xenyx 1002fx Mixer 10 Input 2 Bus with Efx:
"IF your Laptop has a stereo LINE 1/8" INPUT jack, you can take the Stereo ( Left &..."
soundproman7 posted an answer for this Phonic Powerpod K12 Plus 1000W 8 microphone/Line 2 Stereo GEQ DFX Powered Mixer:
"As long as your mixer has a line output jack ( L & R or MONO ), yes."
soundproman7 posted an answer for this Audio Players & Recorders:
"This is very tricky unless your phone system has an analog audio line input provision...."
soundproman7 posted an answer for this Behringer DJx700 5-Channel Pro DJ Mixer with Digital Effects & Bpm Counter:
"Check your cables, make sure they're good and also the connectors on each end, make sure..."
soundproman7 posted an answer for this Behringer Audio Players & Recorders:
"This is relatively easy. All you need are two stereo RCA cables and RCA to 1/4" adapters...."
soundproman7 posted an answer for this Numark DM1200 DJ Mixer:
"Where did you connect the 12Vdc to ?"
soundproman7 posted an answer for this Phonic Helix18fw 18 Channel Mixer with Firewire:
"You don't specify which model Phonic mixer in question. Is it a powered mixer ? And are..."
soundproman7 posted an answer for this Stanton C314 Tabletop CD and Mp3 Player:
"If the button sticks in the down position mechanically, sometimes there is a build up of..."
soundproman7 posted an answer for this Mackie Music:
"You can purchase the channel faders directly from Mackie Service Dept., you can replace..."
soundproman7 posted an answer for this Audio Players & Recorders:
"Unfortunately, the way the mic preamp and gain control are surface mount components on the..."
soundproman7 posted an answer for this Audio Players & Recorders:
"You have to connect an external antenna to the FM ANT. terminals on the back of the..."
soundproman7 posted an answer for this Fender Hot Rod Deluxe Guitar Combo Amplifier :
"You'll have to remove the amplifier section from the speaker cabinet and look inside the..."
soundproman7 posted an answer for this Fender Hot Rod Deluxe Guitar Combo Amplifier :
"It sounds as if you may have to replace the STANDBY-POWER toggle switch."
soundproman7 posted an answer for this Samson Servo 170 Amplifier:
"Disconnect your speakers and see if the same thing happens. If it does not, then you have..."
soundproman7 posted an answer for this Peavey Music:
"http://www.tubesandmore.com/"
soundproman7 posted an answer for this Line 6 Spider Iii 15 Modeling Guitar Amplifier 15 Watt:
"If the buzz disappears when you unplug the cable from the amp. check your cable. If the..."
soundproman7 posted an answer for this Korg Pa800 Synthesizer:
"You should be able to remove the top cover off your keyboard and see the quarter-size..."
soundproman7 posted an answer for this Akai Mpc1000 Sampling Music Production Station:
"If your turntables use ceramic cartridges, you'll need to use a passive interface box that..."
soundproman7 posted an answer for this Crown-Audio XLS 402D Amplif 300 with 8o 450 with 4o XLS402D:
"Most likely the power supply has failed. Could be any component in the power supply..."
soundproman7 posted an answer for this Mackie 1604 Vlz3 16 Channel Mixer:
"This sounds like a dirty connector. Get some good quality electrical connector spray..."
soundproman7 posted an answer for this Behringer DJx700 5-Channel Pro DJ Mixer with Digital Effects & Bpm Counter:
"Always check your cables and connectors on them to make sure the cable is good and the..."