1Itt Tech class of 2007
Anonymous posted an answer for this Mitsubishi WS-55819 55" Rear Projection Television:
"Sounds like you need to replace the Caps in the Dm board there are 4-7 of them if you send..."
AnonymousAnonymous posted an answer for this Mitsubishi WS-55819 55" Rear Projection Television:
"hold down the menu + device for five sec what is the error code? should be like 1 pause..."
AnonymousAnonymous posted an answer for this Mitsubishi WS-55819 55" Rear Projection Television:
"there will be to points on the CRT's hold a screw driver to each point and there should be..."
AnonymousAnonymous posted an answer for this Mitsubishi WS-55819 55" Rear Projection Television:
"hold down the menu + device for five sec what is the error code? should be like 1 pause..."
AnonymousAnonymous posted an answer for this Mitsubishi WS-55819 55" Rear Projection Television:
"hold down the menu + device for five sec what is the error code? should be like 1 pause..."
AnonymousAnonymous posted an answer for this Mitsubishi WS-55819 55" Rear Projection Television:
"ok when the power is plugged in hold down the menu + device buttens for five sec what is..."
Anonymous
Anonymous posted an answer for this Televison & Video:
"replace the Dm caps in the dm board there are 7 of them right on the top of the power..."
Anonymous
Anonymous posted an answer for this Sony KP-61HS10 61" Rear Projection Television:
"your STK 392-110 IC's are bad replace and it will be fine. these chips go bad and its like..."
Anonymous
Anonymous posted an answer for this Akai PT46DL10 46" HDTV-Ready Television:
"I think this would be the lamp pull it out, if its bad you should be able too see the..."
AnonymousAnonymous posted an answer for this Sony KP-61HS10 61" Rear Projection Television:
"your IC's are bad replace and your good to go"
Anonymous
Anonymous posted an answer for this Hitachi 51F500 51" Rear Projection HDTV-Ready Television:
"I had the same problem Replace the IC's and it should fix this"
Anonymous
Anonymous posted an answer for this Hitachi 53UDX10B 53" Rear Projection Television:
"sounds like to be you have a bad solder joints, check solder and make sure the they are..."
AnonymousAnonymous posted an answer for this Hitachi 53UDX10B 53" Rear Projection Television:
"Check the resisters, that could be the burnt small, also you may need to replace the ICs"
Anonymous
Anonymous posted an answer for this Akai PT5598HD 55" Rear Projection HDTV-Ready Television:
"Open the back of the tv and check Fuses, sound like the high volt over loaded"
Anonymous
Televison & Video 14 answers
