Anonymous posted an answer for this 1998 Nissan Quest:
"It is under the intake manifold, in the valley of the motor, can be difficult depends on..."
Anonymous posted an answer for this 2004 Nissan Sentra:
"could be a problem with crank and or cam sensors"
Anonymous posted an answer for this 2005 Nissan Murano:
"sounds like the vehicle is in fail safe mode, could help more but need to know what code..."
Anonymous posted an answer for this Nissan Cars & Trucks:
"Check your brake light switch it may be broken its attached to the brake pedal."
Anonymous posted an answer for this 1997 Nissan Pickup:
"could be worn timing chain guides."
Anonymous posted an answer for this 1996 Nissan Altima:
"Sounds like you could have a vacuum leak in the intake manifold due to a faulty gasket,..."
Anonymous posted an answer for this 2000 Nissan Maxima:
"either a motor mount or strut bearings most likely"
Anonymous posted an answer for this 1995 Nissan Maxima:
"You have to remove the knuckle and get the old bearing and hub pressed out and have the..."
Anonymous posted an answer for this 2003 Nissan 350Z:
"Sounds like the car is stuck in fail safe mode, most likely a problem with your eltronic..."
Anonymous posted an answer for this 2006 Nissan Altima:
"Cleaning thte throttle body is a bad idea on those cars, it has an electronic throttle..."
Anonymous posted an answer for this 2004 Nissan Quest:
"Sounds like your quest is stuck in fail safe mode, most likely could be a problem with..."
Anonymous posted an answer for this 2000 Nissan Maxima:
"It amy be very well be a bad cat. in both banks it is common in those cars, or your ecm..."
Anonymous posted an answer for this 2005 Nissan Quest:
"does the master cylinder have enough brake fluid in it, low fluid level commonly causes..."
Anonymous posted an answer for this 2002 Nissan Altima:
"most likely a crank position sensor or cam position sensor"
Anonymous posted a question about 1999 Audi A4:
"I have a 1999 Audi a4 two wheel drive, my bushings are collapsed in my lower links in the..."