2Hardworking fellow, but likes to enjoy life also!
Mark Eaton posted an answer for this 2000 Harley Davidson FXDWG Dyna Wide Glide:
"Manipulate your harnesses (that is, squeeze, pull, and twist...but gently) while someone..."
Mark Eaton
Mark Eaton posted an answer for this Harley Davidson Motorcycles:
"It is possible. The draw on HD batteries is strong for their size, and connections must..."
Mark Eaton
Mark Eaton posted an answer for this 2003 Suzuki RM 250:
"how do u tell when there is enough oil in the crank case of a 2003 suzuki rm 250 ... there..."
Mark EatonMark Eaton posted an answer for this 2003 Suzuki RM 250:
"On the left side just in front of the sprocket is an Allen head bolt- this is your oil..."
Mark Eaton
Mark Eaton posted an answer for this 1997 kawasaki VN 800 A Vulcan:
"If you try to adjust the monoshock spring, and this does not improve, then you must..."
Mark Eaton
Mark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"Elimination of the PAIR valve and its hardware also makes valve adjustment much..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"If you are referring to the axle nut, it is 45-65 ft. lbs."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"Remove the screw on the bottom of the chrome plastic cover under the headlight, then pop..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"There is no filter, but a screen over the fule pump intake in the tank. You could..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"Pull the rear wheel, the fake swingarm on the left side, and the small plastic cover on..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"This has been discussed in the Vol/C50 forums for some time now; Suzuki maintains that..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"I changed the battery and now the signal lights don't blink?"
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"Make sure that you did not disturb the harness connector for the rear fender lighting; it..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"once I've adjusted my rear cylinder valves the valves on the front cylinder are very loose..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"I will refer you to the Volusia Riders forum archive, one of the best and concise ones..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"You willl have to loosen the nuts that retain the tail light assembly to the fender, then..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"It is not all that unusual for new engines to consume a slight bit more oil during the..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"My bike only has 400 miles and is already a little low on oil. Is this normal?"
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"When correctly set, the valves can be quite loud on startup on these bikes, sometimes..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"I have a c50 2005 it seems to have a very disturbing noise in the engine..I have had the..."
Mark Eaton
Mark Eaton posted an answer for this 1999 kawasaki VN 800 A Vulcan:
"I have a 1999 vulcon 800 classic everytime i hit a bump in the road the engine dies bike..."
Mark EatonMark Eaton posted an answer for this 1999 kawasaki VN 800 A Vulcan:
"Check the kickstand saffety switch to see if it is shorting out when you hit bumps."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"1) Can not find this spec. 2) C50 rake is 33 degrees, Fat Boy's is 32. 3) Many have had..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"1) Fork height of C50 vs Harley fat boy 2) Fork angle of C50 vs Harley fat boy 3) When..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"2007 year model"
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"Remove the handlebar counterweights. Fashion an L-shaped tool from a metal coat hanger,..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"If the bracket is not yet in place, you will need to remove the plastic cover up front..."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"It is a c50 and its an OEM windshield. I have NO instructions at all."
Mark EatonMark Eaton posted an answer for this 2005 Suzuki Boulevard C50:
"Volusias (2004 and earlier): you will have to remove the "fake" frame section from the..."
Mark Eaton
Motorcycles 71 answers
Health & Beauty 4 answers
